The Red Hat firewall

firewall-cmd --permanent --zone=public --add-rich-rule='rule family="ipv4"  source address="158.143.100.0/22"   port protocol="tcp" port="22" accept '
firewall-cmd --reload
 
firewall-cmd --add-rich-rule 'rule family="ipv4" service name="ssh" source address="158.143.100.0/22" accept'

firewall-cmd --permanent --zone=public --add-rich-rule='rule family="ipv4" source address="158.143.100.0/22" port protocol="tcp" port="22" accept ' firewall-cmd --reload

firewall-cmd --add-rich-rule 'rule family="ipv4" service name="ssh" source address="158.143.100.0/22" accept'

less /etc/sysconfig/system-config-firewall
The configuration for firewalld is stored in various XML files in /usr/lib/firewalld/ and /etc/firewalld/. This allows a great deal of flexibility as the files can be edited, written to, backed up, used as templates for other installations and so on.
systemctl status firewalld

firewall-cmd --permanent --zone=public --list-all
iptables-save
service firewalld stop
service firewalld start
systemctl disable firewalld
systemctl enable firewall-cmd --permanent --zone=public --add-rich-rule='rule family="ipv4"  source address="158.143.100.0/22"   port protocol="tcp" port="22" accept '

firewall-cmd --reload

firewall-cmd --add-rich-rule 'rule family="ipv4" service name="ssh" source address="158.143.100.0/22" accept' firewalld

firewall-cmd
firewall-cmd status
firewall-cmd --get-active-zone

Reference - https://www.certdepot.net/rhel7-get-started-firewalld/

firewall-cmd --permanent --zone=trusted --add-source=192.168.2.0/24
firewall-cmd --reload
firewall-cmd --zone=trusted --list-sources
Note: Add the –permanent option if you only want to display permanent settings.

Example

firewall-cmd --zone=internal --add-service=ssh --permanent
firewall-cmd --zone=internal --add-source=1.2.3.4/32 --permanent
firewall-cmd --zone=public --remove-service=ssh --permanent
firewall-cmd --reload

Rich rules

firewall-cmd --permanent --zone=public --add-rich-rule="rule family="ipv4" \
source address="1.2.3.4/32" \
port protocol="tcp" port="4567" accept"

Check the zone file later to inspect the XML configuration
cat /etc/firewalld/zones/public.xml

Reference - https://access.redhat.com/documentation/en-US/Red_Hat_Enterprise_Linux/7/html/Security_Guide/sec-Using_Firewalls.html